Test 13A - No Response From Powertrain Control Module
NOTE:
For connector terminal identification and wiring diagrams, see BODY CONTROL COMPUTER
(JA Body) or BODY CONTROL COMPUTER
(JX Body) articles. Perform TEST VER-1 after each repair.
CAUTION:
Always turn ignition off prior to disconnecting any module connector.
- Disconnect Powertrain Control Module (PCM). PCM is located next to air cleaner. Turn ignition on. Connect jumper wire between ground and PCM connector, terminal No. 59 (Violet/Brown wire).
- Using scan tool, select BODY, BODY COMPUTER, then SYSTEM TEST. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, go to step 5). If scan tool displays BUS SHORT TO GROUND, go to next step.
- Move jumper wire to terminal No. 60 (White/Black wire). Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, go to next step. If scan tool displays BUS SHORT TO GROUND, replace PCM.
- Connect jumper wire between ground and Body Control Module (BCM) 22-pin connector, terminal No. 13 (White/Dark Green wire). Do not disconnect connector. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, replace BCM. If scan tool displays BUS SHORT TO GROUND, repair open White/Dark Green wire.
- Connect jumper wire between ground and Body Control Module (BCM) 14-pin connector, terminal No. 5 (Violet/Brown wire). Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, replace BCM. If scan tool displays BUS SHORT TO GROUND, repair open Violet/Brown wire.