Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1996 >> Sebring JXi >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer - Convertible >> Diagnostic Charts >> Power Door Lock Test 2D - Shorted Door Unlock Driver Circuit

Power Door Lock Test 2D - Shorted Door Unlock Driver Circuit

NOTE: Perform POWER DOOR LOCK TEST 2A before proceeding with this test. For connector terminal identification and wiring diagrams, see CONNECTOR IDENTIFICATION in appropriate BODY CONTROL COMPUTER section in this article. Perform VERIFICATION TEST VER-1A after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Disconnect BCM 20-pin connector located at junction block and ensure connector is clean and not damaged. See Figure in CHIME TEST 3A. Using external ohmmeter, measure resistance of BCM 20-pin connector terminals No. 1 (Pink/Light Blue wire), No. 2 (Pink/Dark Blue wire), No. 3 (Pink/Black wire) and No. 4 (Dark Blue/White wire).
  2. If resistance is less than 5 ohms, repair shorted door unlock driver circuit, replace fuse No. 9 and replace BCM (relay in BCM will be damaged). If resistance is 5 ohms or greater on any of tested circuits, replace BCM.
scientia non olet · About Mike's Workshop Manuals