Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1995 >> LeBaron >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 28A - Electronic Instrument Cluster (EIC) Odometer/Speedometer Failure

Test 28A - Electronic Instrument Cluster (EIC) Odometer/Speedometer Failure

NOTE: Perform TEST VER-1 after each repair.
CAUTION: Always turn ignition off prior to disconnecting or connecting any module connector.
  1. Raise and support vehicle. Start engine. Place gear selector in Drive position (1st gear on manual trans). Go to next step.
  2. Using scan tool, read Vehicle Speed Sensor (VSS) signal. If VSS signal does not increase smoothly with acceleration, refer to appropriate ELECTRONIC INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. If VSS signal increases smoothly with acceleration, go to next step.
  3. Check if problem is with odometer only. If problem is not with odometer only, replace instrument cluster. If problem is with odometer only, replace body control module.
scientia non olet · About Mike's Workshop Manuals