Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1995 >> Cirrus LXi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Interior Light Test 4A - Courtesy Light Inoperative With Dome Light Switch

Interior Light Test 4A - Courtesy Light Inoperative With Dome Light Switch

NOTE: Perform INTERIOR LIGHT TEST 1A  before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER INTRODUCTION. Perform TEST VER-1A  after each repair.
CAUTION: Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
  1. Ensure dome light switch is in the middle position before proceeding. Locate junction block 6-pin connector below horn relay. See Figure in CHIME TEST 3A. Using a jumper wire, backprobe junction block 6-pin connector terminal No. 4 (Black wire) to ground. If dome light does not come on, leave jumper wire connected and go to next step. If dome light comes on, replace junction block.
  2. Disconnect dome light 3-pin connector and ensure connector is clean and not damaged. Using scan tool in ohmmeter mode, check resistance of dome light 3-pin connector terminal No. 1 (Black wire). If resistance is less than 5 ohms, replace dome light assembly. If resistance is more than 5 ohms, repair open Black wire.
scientia non olet · About Mike's Workshop Manuals