Instrument Cluster Test 9A - Low Fuel Warning Light
NOTE:
Perform INSTRUMENT CLUSTER TEST 4A
before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION in BODY CONTROL COMPUTER INTRODUCTION. Perform TEST VER-1A
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting or connecting any module connector.
- If low fuel light is on when it should be off, replace BCM. If low fuel light is off when it should be off and on when it should be on, go to next step.
- Turn ignition to UNLOCK position. Using scan tool, actuate ALL LAMPS. If low fuel light comes on and then goes off, replace BCM. If low fuel light does not come on, go to next step.
- Disconnect instrument cluster and ensure connectors are clean and not damaged. Remove low fuel warning bulb and replace if defective. See Figure in INSTRUMENT CLUSTER TEST 8A. Inspect instrument cluster and ensure bulb socket is clean and not damaged. Repair or replace instrument cluster as necessary.