Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1994 >> LHS >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Alternator & Regulator) >> Self-Diagnostic System >> DRB Test Functions >> DRB Volt/Ohmmeter Mode

DRB Volt/Ohmmeter Mode

WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
  1. To access volt/ohmmeter mode of DRB, connect Red volt/ohmmeter test lead to Red port, located on right-top side of DRB.
  2. To place DRB in voltmeter mode, press VOLT/OHM key once. Touch test probe to connector or wire to be measured. Read voltage on DRB display. When voltage testing is complete, press VOLT/OHM key 3 times to exit voltmeter mode.
  3. To place DRB in ohmmeter mode, press VOLT/OHM key twice. Touch test probe to connector or wire to be measured. Read resistance to circuit ground on DRB display. When resistance testing is complete, press VOLT/OHM key twice to exit ohmmeter mode.
scientia non olet · About Mike's Workshop Manuals