Test VER-1 - Verification Procedure

WARNING: This page is about a different car, the 1994 Plymouth Acclaim, 1994 Dodge Spirit, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS. After each repair, perform TEST VER-1.

Reconnect all components and connectors that were disconnected for testing. Verify all repairs have been made. Turn ignition switch to OFF position, then back to ON position. Using DRB, clear all trouble codes and actuate system which was not operational. If system operates properly, repair is complete. If system is still malfunctioning, go to TEST 1A.