Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1994 >> LHS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - Body Control Computer >> Self-Diagnostic Tests >> Test 35E - All Doors Fail To Lock & Unlock From One SW

Test 35E - All Doors Fail To Lock & Unlock From One SW

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION  . For wiring diagrams, see WIRING DIAGRAMS  . Perform TEST VER-1 after each repair.
  1. Remove appropriate door trim panel. Disconnect door lock switch connector. Using DRB in voltmeter mode, check voltage on door lock switch connector terminal No. 4 (Pink wire). If voltage is less than 10 volts, repair open Pink wire. If voltage is more than 10 volts, go to next step.
  2. Connect jumper wire between door lock switch connector terminals No. 1 (Orange/Violet wire) and No. 4 (Pink wire). Using DRB, read door lock switch voltage. If voltage is less than 8 volts, repair open Orange/Violet wire. If voltage is more than 8 volts, replace door lock switch.
scientia non olet · About Mike's Workshop Manuals