Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1994 >> LHS >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> A/C-Heater System - Manual >> Testing >> DRB Test Functions >> Notes

DRB Test Functions: Notes

NOTE: Do not touch DRB keypad during DRB power-up sequence, or an error message will result. Ensure correct DRB cartridge is being used.
  1. In order to perform diagnostic tests using the DRB, the DRB must be in the LH CLIMATE CONTROL menu. At the LH CLIMATE CONTROL menu, fault codes and DRB test functions can be accessed.
  2. To reach LH CLIMATE CONTROL menu, turn ignition off. Attach DRB to data link (diagnostic) connector. Connector is located under instrument cluster, next to center console. See Figure . Turn ignition switch to RUN position.
  3. All DRB character positions will illuminate and copyright information will appear on screen for a few seconds. If DRB screen is blank or any error messages appear, see DRB PROBLEMS & ERROR MESSAGES.
  4. After a few seconds, the DRB menu will appear. At DRB menu, press "4" (SELECT SYSTEM) key to enter diagnostic test program. Press down arrow 3 times to change menu display.
  5. At SELECT SYSTEM menu, select "9" (LH CLIMATE CONT) key to enter climate (A/C-heater) control part of the DRB program. After a few seconds, the LH CLIMATE CONTROL menu will appear. The screen will display a menu of the DRB test categories for the A/C-heater system.
  6. At LH CLIMATE CONTROL menu of A/C-heater system diagnostic program, specific test functions programmed into DRB cartridge can be performed. The following DRB modes can be accessed: CLIMATE TESTS, CLIMATE FAULTS, CLIMATE STATE, CLIMATE ACTUATORS and CLIMATE ADJUSTMENT.
scientia non olet · About Mike's Workshop Manuals