Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1985 >> Laser Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Adjustment >> Cruise Control Throttle Cable >> FWD Models

FWD Models

  1. Clearance between throttle stud and cable clevis should be 1/16" (1.6 mm). If not, start engine and run at normal operating temperature. Engine should be curb idle. Remove snap ring from throttle stud.
  2. Loosen cable retaining clamp nut. Pull all slack out of cable, but do not move throttle away from curb idle position. Tighten retaining nut to 45 INCH lbs. (5 N.m).
scientia non olet · About Mike's Workshop Manuals