Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chrysler >> 1984 >> E Class 2.2 E >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> A/C System General Servicing >> Compressor Oil Checking >> During System Discharging

During System Discharging

  1. Slowly discharge system using approved refrigerant recovery/recycling equipment. Disconnect refrigerant hoses at compressor. Remove compressor mounting bolts, and remove compressor.
  2. Remove suction port on top of compressor, and drain oil. Add proper amount of refrigerant oil to compressor (total system capacity minus amount retained in components that have not been replaced). See C-171 COMPONENT REFRIGERANT OIL CAPACITIES table below.
  3. Install compressor. Evacuate and recharge A/C system. Perform leak test.
C-171 COMPONENT REFRIGERANT OIL CAPACITIES

Component Ounces
Condenser 1.0
Evaporator
Front 2.0
Rear (If Equipped) 2.0
Receiver-Drier 1.0
scientia non olet · About Mike's Workshop Manuals