Removal Procedure
- Disable the SIR system. SIR Disabling and Enabling
Center Pillar Lower Garnish Molding Lower Hole Cover (1) - Remove
Front Seat Belt Anchor Plate Tensioner Cover (1) - Remove
- Front Seat Belt Anchor Plate Tensioner Bolt (2) - Remove
Use a small flat - bladed tool to open the bolt cap (1) and gain access to the bolt.
- Center Pillar Upper Trim Panel Bolt Cap (1) - Remove
- Center Pillar Upper Garnish Molding Bolt (2) - Remove
- Pull the Center Pillar Upper Trim Panel (3) toward the inside of the vehicle to disengage the clips.
- Feed the seat belt through the Center Pillar Upper Trim Panel (3).
- Center Pillar Upper Trim Panel (3) - Remove
Front Seat Belt Guide Bolt (1) - Remove
Front Seat Belt Adjust Bolt (1) - Remove [2x]
- Front Seat Belt Guide Adjuster (2) - Remove