Removal Procedure
Liftgate Inside Pull Handle Cover (1) - Remove
- Liftgate Lower Trim Finish Panel Bolt (2) - Remove
- Liftgate Lower Trim Finish Panel (3) - Remove
- Disconnect the electrical connector.
Release the washer hose grommet at the liftgate.
- Disconnect the rear washer hose. (1)
- Disconnect the electrical connectors and release the wiring harness retainers as necessary. (2)
- Release the wiring harness from the liftgate.
- Rear Closure Center Applique Nut (3) - Remove [9x]
Rear Closure Center Applique Clip (1) - Release [8x]
- Rear Closure Center with License Plate Lamp Applique (2) - Remove
Disconnect the electrical connector (1).
Liftgate Release Switch - Exterior (1) - Remove