Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Vehicle Access System) >> Diagnostic Information and Procedures >> DTC B17FC or B17FD >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition/vehicle OFF, disconnect the connector at the B27LF Front Side Door Outside Handle Switch - Left. Ignition ON
  2. Verify the scan tool Left Front Door Exterior Lock/Unlock Switch Status parameter is Inactive
    • If not Inactive 
    1. Test the circuit 2674 for a short to ground
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found.
    2. Replace the K9 Body Control Module.
    • Go to next step: If Inactive 
  3. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground.
  4. Verify the scan tool parameter is now Active.
    • If not Active and the 3 A fuse is OK 
    1. Test the circuit 2674 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the K9 Body Control Module.
    • If not Active and the 3 A fuse is open 
    1. Test the circuit 2674 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
    2. Replace the K9 Body Control Module.
    • Go to next step: If Active 
  5. Replace the B27LF Front Side Door Outside Handle Switch - Left
scientia non olet · About Mike's Workshop Manuals