Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Tire Pressure Monitoring System) >> Diagnostic Information and Procedures >> DTC C116D >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

DTC C116D 54

Perform the following learn procedure: Tire Pressure Indicator Sensor Learn .

DTC C116D 56

  1. Ignition On/Vehicle in Service Mode.
  2. Enter the tire type and pressure (placard) information into the K9 Body Control Module with a scan tool. Refer to Vehicle Certification, Tire Placard, and Anti-Theft Label , Control Module References .
  3. Perform the following learn procedure: Tire Pressure Indicator Sensor Learn .
  4. Ignition OFF, then Ignition On/Vehicle in Service Mode.
  5. Verify DTC C116D 56 is not set.
    • If the DTC is set 

      Replace the K9 Body Control Module

    • Go to next step: If the DTC is not set 
  6. All OK.
scientia non olet · About Mike's Workshop Manuals