Windshield Wiper Motor Replacement

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Windshield Wiper Transmission Replacement
1	Windshield Wiper Motor Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Windshield Wiper Motor Procedure Use the B0-39232 separator to separate the transmission drive link from the wiper motor crank arm ball stud. Use the B0-39529 installer to install the transmission drive link onto the wiper motor crank arm ball stud. NOTE: Apply a small amount of grease to the inner cup on the transmission link to aid in installation. Special Tools B0-39232 Wiper Linkage Separator B0-39529 Wiper Linkage Installer Equivalent regional tools: Special Tools

Callout

Component Name

Windshield Wiper Motor Bolt [2x]

CAUTION:

Tighten
9 N.m (80 lb in)

Windshield Wiper Motor

Procedure

Use the B0-39232 separator to separate the transmission drive link from the wiper motor crank arm ball stud.
Use the B0-39529 installer to install the transmission drive link onto the wiper motor crank arm ball stud.

NOTE:

Apply a small amount of grease to the inner cup on the transmission link to aid in installation.

Special Tools

Equivalent regional tools: Special Tools