Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Starting System And Charging System - Repair Instructions >> Repair Instructions >> Engine Wiring Harness Junction Block Replacement >> Installation Procedure

Installation Procedure

  1. Engine Wiring Harness Junction Block (3) - Install
    GM5572883Courtesy of GENERAL MOTORS COMPANY
  2. Retaining Tab (1) - Engage [4x]
    3. CAUTION:

    Refer to Fastener Caution

  3. Engine Wiring Harness Junction Block Bolt (2) - Tighten [4x] - Fastener Specifications
  4. Starter Solenoid Cable (4) - Install
    GM5572790Courtesy of GENERAL MOTORS COMPANY
  5. Battery Positive Cable Nut (3) - Install and tighten - Fastener Specifications
  6. Engine Wiring Harness Junction Block Cover (2) - Install
  7. Retaining Tab (1) - Engage [2x]
  8. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9) 
scientia non olet · About Mike's Workshop Manuals