Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Tahoe SSV >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Image Display Camera System >> Diagnostic Information and Procedures >> DTC B1236 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Disconnect the electrical connector: X2@A11 Radio
  3. Apply the parking brake.
  4. Engine Running & Transmission in Reverse
  5. Verify a test lamp turns On between the test points: Control circuit terminal 13 & Ground
    • If the test lamp does not turn On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Test for less than 2 ohms between the test points: Control circuit terminal 13 @Component harness & The other end of the circuit
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • Go to next step: If less than 2 ohms
    3. Test for infinite resistance between the test points: Control circuit terminal 13 & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Test or replace the component: K219 Exterior Lighting Control Module
    • Go to next step: If the test lamp turns On 
  6. Ignition/Vehicle & All vehicle systems - Off
  7. Disconnect the electrical connector: X5@A11 Radio
    8. NOTE:

    Before testing the coax cable, check the cable's exterior for being pinched, cut, damaged, or having loose connections at the components, all of which can cause reception issues.

  8. Disconnect the electrical connector: X3@K157 Video Processing Module
  9. Locate the appropriate pinout adapter and load test loop adapter from EL-52552 COAX FAKRA Cable Adaptor Kit.
  10. Connect the 2 adapters together, measure and record the resistance between the terminals at the pinout adapter.
  11. Disconnect the 2 adapters and connect each one to the appropriate end of the coax cable.
  12. At the pinout adapter test terminals, measure the total resistance of the coax cable loop including the connected load test adapter.
    • If not within 5 Ω of the reading from step 10. 

      Replace the coax cable

    • Go to next step: If within 5 Ω of the reading from step 10. 
  13. Replace the component: K157 Video Processing Module
  14. Apply the parking brake.
  15. Engine RunningTransmission in Reverse
  16. Verify DTC B1236 is not set.
    • If the DTC is set 

      Replace the component: A11 Radio

    • Go to next step: If the DTC is not set 
  17. All OK.
scientia non olet · About Mike's Workshop Manuals