Removal Procedure
WARNING: This page is about a different car, the 2021 GMC Sierra 1500. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. SIR Disabling and Enabling
- NOTE:
Some components not shown for graphic clarity.
Rear Seat Belt Retractor Anchor Plate Bolt-Right Side (1) - Remove
- Reposition the right side rear seat belt retractor anchor plate (2) out from underneath the rear floor panel carpet.
Pull the right side body side rear window garnish molding (1) rearwards to release the tether from the body side inner frame.
- Access the right side quarter window trim finish panel bolt (2) which is located on the backside of the rear window garnish molding (1) and secures the tether to the body side inner frame.
- Quarter Window Trim Finish Panel Bolt-Right Side (2) - Remove
- Route the seat belt webbing through the right side body lock pillar garnish molding (1).
- Body Side Rear Window Garnish Molding-Right Side (1) - Remove
Disconnect the electrical connector.
- Release the retaining tabs.
- Remote Function Actuator Module (1) - Remove
NOTE:
Tether and quarter window trim finish panel bolt (2) are integral to the body side rear window garnish molding (1).