Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Silverado 1500 SSV, RWD, Gas >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Remote Functions >> Repair Instructions >> Remote Function Actuator Module Replacement (Crew Cab, Double Cab) >> Removal Procedure

Removal Procedure

  1. Disable the SIR system. SIR Disabling and Enabling
    GM5651585Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Some components not shown for graphic clarity.

  2. Rear Seat Belt Retractor Anchor Plate Bolt-Right Side (1) - Remove
  3. Reposition the right side rear seat belt retractor anchor plate (2) out from underneath the rear floor panel carpet.
    GM5027777Courtesy of GENERAL MOTORS COMPANY
  4. Pull the right side body side rear window garnish molding (1) rearwards to release the tether from the body side inner frame.
    NOTE:

    Tether and quarter window trim finish panel bolt (2) are integral to the body side rear window garnish molding (1).

  5. Access the right side quarter window trim finish panel bolt (2) which is located on the backside of the rear window garnish molding (1) and secures the tether to the body side inner frame.
  6. Quarter Window Trim Finish Panel Bolt-Right Side (2) - Remove
  7. Route the seat belt webbing through the right side body lock pillar garnish molding (1).
  8. Body Side Rear Window Garnish Molding-Right Side (1) - Remove
    GM5034586Courtesy of GENERAL MOTORS COMPANY
  9. Disconnect the electrical connector.
  10. Release the retaining tabs.
  11. Remote Function Actuator Module (1) - Remove
scientia non olet · About Mike's Workshop Manuals