Circuit/System Verification

Ignition - On/Vehicle - In Service Mode
Perform the scan tool control function: Left Rear Window Motor - Up & Down
Verify the component operates in both directions: M74LR Window Motor - Left Rear
- If the component does not work as specified
  Replace the component: M74LR Window Motor - Left Rear
- Go to next step: If the component works as specified
Perform the scan tool control function: Right Rear Window Motor - Up & Down
Verify the component operates in both directions: M74RR Window Motor - Right Rear
- If the component does not work as specified
  Replace the component: M74RR Window Motor - Right Rear
- Go to next step: If the component works as specified
Switch - Rear Window @ S79D Window Switch - Driver = Activated
Operate the component: Driver Window Switch & Passenger Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the scan tool parameter:
- Left Rear Window Main Control Down Switch = Inactive & Active
- Left Rear Window Main Control Express Switch = Inactive & Active
- Left Rear Window Main Control Up Switch = Inactive & Active
- Right Rear Window Main Control Down Switch = Inactive & Active
- Right Rear Window Main Control Express Switch = Inactive & Active
- Right Rear Window Main Control Up Switch = Inactive & Active
- Front Passenger Window Main Control Down Switch = Inactive & Active
- Front Passenger Window Main Control Express Switch = Inactive & Active
- Front Passenger Window Main Control Up Switch = Inactive & Active
- If not the specified state
  Replace the component: S79D Window Switch - Driver
- Go to next step: If the specified state
Verify DTC B3205 4B is not set.
- If DTC B3205 4B is set
  Use the following procedure: Window Motor Programming - Express Function .
- Go to next step: If the DTC is not set
Switch - Rear Window @ S79D Window Switch - Driver = Not Activated
Operate the component: Driver Window Switch @ S79D Window Switch - Driver - Pressed & Pulled
Verify the component works as specified:
- M74D Window Motor - Driver = Up
- M74D Window Motor - Driver = Express Up
- M74D Window Motor - Driver = Down
- M74D Window Motor - Driver = Express Down
- If not the specified state
  Refer to: Circuit/System Testing - Test 1
- Go to next step: If the specified state
Verify DTC B3210 4B is not set.
- If DTC B3210 4B is set
  Use the following procedure: Window Motor Programming - Express Function .
- Go to next step: If the DTC is not set
Operate the component: S79P Window Switch - Passenger - Pressed & Pulled
Verify the component works as specified:
- M74P Window Motor - Passenger = Up
- M74P Window Motor - Passenger = Express Up
- M74P Window Motor - Passenger = Down
- M74P Window Motor - Passenger = Express Down
- If not the specified state
  Refer to: Circuit/System Testing - Test 2
- Go to next step: If the specified state
All OK.