Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2021 >> Bolt EV Premier >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Plug-In Charging System) >> Diagnostic Information and Procedures >> DTC P0D4D-P0D4F >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2020 Chevrolet Bolt EV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0D4E or P0D4F is not set; or DTC P0D4D is set along with either DTC P0D4E or P0D4F.
    • If DTC P0D4E or P0D4F is set 

      Refer to Circuit/System Testing.

    • Go to next step: If DTC P0D4D is set without P0D4E, P0D4F; or none of the DTCs are set 
  2. Clear DTC Information. Connect the vehicle to an AC drive motor battery charger cable to begin charging. Vehicle in Service Mode.
  3. Verify that DTC P0D26 is not set and that the vehicle will charge.
    • Go to next step: If the DTC is not set and that the vehicle will charge 
  4. Verify that DTC P0D4D is not set.
    • If the DTC is set 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About Mike's Workshop Manuals