Installation Procedure
Position the starter motor (2) to the engine block.
- Install the starter motor mounting fasteners (1) and tighten to 58 N.m (43 lb ft).
Install the battery positive cable and engine harness connector to the starter and tighten the battery positive cable fastener (1) to 9 N.m (80 lb in).
- Install the engine harness connector to the starter solenoid.
- Connect the knock sensor connector.
Install the starter heat shield (2) and tighten the fastener (1) to 5 N.m (44 lb in).
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .