Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Drivetrain and Front Suspension Frame Rear Support-to-Body Bolt | |
|
60 N.m (44 lb ft) |
|
30 - 40 Degrees |
| Rear Suspension Support-to-Body Bolt | |
|
90 N.m (66 lb ft) |
|
120 - 135 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Compartment Air Deflector Bolt | 3 N.m (27 lb in) |
| Front Compartment Splash Shield Bolt | 3 N.m (27 lb in) |
| Drivetrain and Front Suspension Frame Retaining Bolt | 160 N.m (118 lb ft) |
| Front Transmission Mount-to-Frame Bolt | 100 N.m (74 lb ft) |
| Front Wheelhouse Panel Splash Shield Bolt | 2.5 N.m (22 lb in) |
| Rear Transmission Mount-to-Frame Bolt | 100 N.m (74 lb ft) |
| Side Member Reinforcement Bolt | 22 N.m (16 lb ft) |
| Underbody Front Air Deflector Bolt | 2.5 N.m (22 lb in) |
| Underbody Rear Air Deflector Bolt | 2.5 N.m (22 lb in) |
| Underbody Rear Air Outer Deflector Bracket Fastener | 3 N.m (27 lb in) |