Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Trax LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Antilock Brake System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2768795

    Install the wheel speed sensor (1) to the rear suspension knuckle.

  2. GM2768794
    CAUTION:

    Refer to Fastener Caution .

    Install the wheel speed sensor bolt (1) and tighten to 8 N.m (71 lb in).

  3. GM2768792

    Install the wheel speed sensor harness clips (1) to the rear axle.

  4. GM2768790

    Connect the wheel speed sensor electrical connector (1) and install the connector clip to the wheelhouse bracket.

  5. Install the wheel speed sensor harness clip (2) to the wheelhouse panel.
  6. Install the rear wheelhouse panel liner. Refer to Rear Wheelhouse Liner Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About Mike's Workshop Manuals