Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Trax LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Lighting System - Repair Instructions) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2770201
    NOTE:

    Ensure the fork of the brake pedal position sensor is positioned over the brake pedal post.

    Install the brake pedal position sensor (1).

  2. GM2770200
    CAUTION:

    Refer to Fastener Caution .

    Install the brake pedal position sensor bolt (1) and tighten to 3 N.m (27 lb in).

  3. Install the left side front floor air outlet duct. Refer to Floor Front Air Outlet Duct Replacement - Left Side (Chevrolet)Floor Front Air Outlet Duct Replacement - Left Side (Buick) .
  4. Connect the brake pedal position sensor electrical connector.
  5. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .
scientia non olet · About Mike's Workshop Manuals