Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Trax LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Disc Brake System) >> Repair Instructions >> Front Brake Caliper Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM1873956

    Install the brake caliper bracket (1).

  2. GM1873953
    CAUTION:

    Refer to Fastener Caution .

    Install new brake caliper bracket bolts (1) and tighten to 160 N.m (118 lb ft).

  3. GM1873947

    Install the disc brake pad springs (1).

  4. GM2375922

    Install the 2 brake caliper guide pin seals.

  5. Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper bracket.
    6. NOTE:

    The upper brake caliper guide pin is equipped with a bushing and must be installed in the same location.

  6. Install the upper brake caliper guide pin (1).
  7. Install the lower brake caliper guide pin (2).
  8. Ensure the brake caliper guide pin seals are fully seated in the groove of the brake caliper guide pins.
  9. GM2375921
    NOTE:

    Note the location of the wear sensor for correct installation.

    Install the inner disc brake pad (1).

  10. Install the outer disc brake pad (2).
  11. Position the brake caliper over the disc brake pads and to the caliper bracket.
  12. GM2375920

    Install the brake caliper guide pin bolts (1). Front Brake Caliper Replacement 

  13. Install the tire and wheel assembly. Tire and Wheel Removal and Installation
scientia non olet · About Mike's Workshop Manuals