Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Trax LS, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement (LUV) >> Installation Procedure

Installation Procedure

  1. GM2191725Courtesy of GENERAL MOTORS COMPANY

    Install the starter (3).

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the washer (5) and the starter mounting fastener stud (4). Tighten to 25 N.m (18 lb ft).
  3. Install the upper starter mounting fastener (2) and the washer (1). Tighten to 25 N.m (18 lb ft).
  4. GM2191724Courtesy of GENERAL MOTORS COMPANY

    Install the battery negative ground cable (6) and tighten the fastener (5) to 17 N.m (13 lb ft).

  5. Install the engine harness cable (4) to starter solenoid and tighten the fastener (3) to 5.5 N.m (49 lb in).
  6. Install the battery positive cable (1) and tighten the fastener (2) to 13 N.m (115 lb in).
  7. GM2777069Courtesy of GENERAL MOTORS COMPANY

    Install the heated oxygen sensor bracket (2) and tighten the fastener (1) to 22 N.m (16 lb ft).

  8. If equipped with AWD, install the transfer case. Refer to Transfer Case Replacement .
  9. Install the drivetrain and front suspension frame transmission protector. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without KL9) Battery Negative Cable Disconnection and Connection (with KL9) .
scientia non olet · About Mike's Workshop Manuals