Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Spark LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0121 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2018 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the K17 Electronic Brake Control Module (EBCM).
  2. Test for less than 5 Ω between the ground circuit terminals listed below:
    • Ground circuit terminal 13 and ground.
    • Ground circuit terminal 38 and ground.
    • If greater than 5 Ω 

      Test/repair the ground circuit for an open/high resistance.

    • Go to next step: If less than 5 Ω 

      Go to next step: Replace the K17 Electronic Brake Control Module

scientia non olet · About Mike's Workshop Manuals