Circuit/System Testing
- Ignition/Vehicle & All vehicle systems - Off
- Disconnect the electrical connector:Coax Cable @ A11 Radio & T23 Radio Antenna Amplifier
- Perform the following procedure/test:Coax Cable - Component Testing
Verify the procedure/test passes.
- If the component does not work as specified
Replace the component:Coax Cable
- Go to next step: If the components test normal
- If the component does not work as specified
- Connect the component:Coax Cable @ A11 Radio
- Ignition - On / Vehicle - In Service Mode - A11 Radio - ON
- Verify a test lamp turns On between the test points:Coax Cable Center @ T23 Radio Antenna Amplifier & Ground
- If the test lamp does not turn On
- Replace the component:A11 Radio
- Go to next step: If the test lamp turns On
- Test or replace the component:T23 Radio Antenna Amplifier