Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Express 2500 LS, 2.8L Eng VIN 1 >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Starting System And Charging System >> Repair Instructions >> Battery Current Sensor Replacement (LV1) >> Installation Procedure

Installation Procedure

  1. Battery Negative Cable(3) - Install
  2. Retainer(1) - Engage[3x]
    3. CAUTION:

    Refer to Fastener Caution

  3. Battery Negative Cable Ground Bolt(2) - Install and tighten22N.m (16 lb ft)
  4. GM5128775Courtesy of GENERAL MOTORS COMPANY

    Retainer(1) - Engage

  5. Battery Negative Cable Ground Bolt(2) - Install and tighten10N.m (89 lb in)
  6. Install the right front tire and wheel assembly. Tire and Wheel Removal and Installation (Without Dual Rear Wheels)Tire and Wheel Removal and Installation (With Dual Rear Wheels)
  7. Lower the vehicle.
  8. GM5128767Courtesy of GENERAL MOTORS COMPANY

    Battery Negative Cable Ground Bolt(1) - Install and tighten10N.m (89 lb in)

  9. Retainer(2) - Engage
  10. Electrical Connector(3) - Connect
  11. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery) Battery Negative Cable Disconnection and Connection (Dual Battery) 
scientia non olet · About Mike's Workshop Manuals