Installation Procedure
WARNING: This page is about a different car, the 2018 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Ensure the grease does not contaminate the following parts:
- wheel speed sensor bore holes
- bearing fastener threads
- wheel speed sensor
Grease the steering knuckle surface of the front wheel speed sensor (1).
- Grease the steering knuckle surface of the front wheel bearing/hub (2).
Position the front brake shield (2) and wheel bearing/hub assembly (1) in the steering knuckle.
- WARNING:
refer to Torque-to-Yield Fastener Warning .
CAUTION:This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur.
CAUTION:refer to Fastener Caution .
Install and tighten the NEW bolt. [4x]
Tighten the bearing/hub bolts (1) a first pass to.
- First Pass: 90 N.m (66 lb ft)
- Final Pass: 60 - 75 degrees - EN-45059 meter
Install the wheel speed sensor wiring harness to the steering knuckle.
- Install the wheel speed sensor (2).
- Install the wheel speed sensor bolt (1) and tighten to 6 N.m (53 lb in).
- Install the Brake Rotor. refer to Front Brake Rotor Replacement .
- Install the NEW wheel drive shaft retaining nut and washer. refer to Front Wheel Drive Shaft Replacement .
- remove the support and lower the vehicle.