Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2019 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Suspensions Control System) >> Repair Instructions >> Electronic Suspension Front Position Sensor Replacement >> Installation

Electronic Suspension Front Position Sensor Replacement: Installation

WARNING: This page is about a different car, the 2020 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM2868527Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that the level senor is properly seated on the frame rail.

    Position the level sensor (3) on the frame rail.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the level senor nut (4) to 9 N.m (80 lb in).
  3. Install the level sensor link (2) on the lower control arm ball stud (1).
  4. GM2868517Courtesy of GENERAL MOTORS COMPANY

    Reconnect the level sensor electrical connector (2) to the electronic level sensor (1).

  5. Install the front wheel house liner. Refer to Front Wheelhouse Liner Replacement , or Front Wheelhouse Liner Replacement (ZL1) .
  6. Remove the support and lower the vehicle.
  7. Reprogram the level sensor.
scientia non olet · About Mike's Workshop Manuals