Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Traverse L >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Antilock Brake System) >> Diagnostic Information and Procedures >> DTC C0245 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the K17 Electronic Brake Control Module, ignition ON.
  2. Test for less than 1 V between the K17 Electronic Brake Control Module harness connector terminals listed below and ground:
    • B5LF Wheel Speed Sensor - Left Front - terminal 5
    • B5LR Wheel Speed Sensor - Left Rear - terminal 16
    • B5RF Wheel Speed Sensor - Right Front - terminal 11
    • B5RR Wheel Speed Sensor - Right Rear - terminal 29
    • If 1 V or greater 

      Repair the short to voltage on the circuit.

    • Go to next step: If less than 1 V 
  3. All OK.
scientia non olet · About Mike's Workshop Manuals