Liftgate Power Assist Actuator Replacement

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Body Rear Corner Upper Garnish Molding Replacement
1	Liftgate Power Assist Actuator WARNING: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. Procedure Disconnect the electrical connector. Release the strut clips. Ensure the clip is fully seated when rod is reinstalled. If clip cannot be fully seated, a new rod should be installed. Perform the necessary programming and setup procedure: Liftgate Calibration

Callout

Component Name

Preliminary Procedure
Body Rear Corner Upper Garnish Molding Replacement

Liftgate Power Assist Actuator

WARNING:

When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

Procedure

Disconnect the electrical connector.
Release the strut clips.
Ensure the clip is fully seated when rod is reinstalled. If clip cannot be fully seated, a new rod should be installed.
Perform the necessary programming and setup procedure: Liftgate Calibration