Removal Procedure
The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.
Fuel/gasoline vapors are highly flammable. A fire could occur if an ignition source is present. Never drain or store gasoline or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.
Wear safety glasses in order to avoid eye damage.
Refer to Fuel and Evaporative Emission Hose/Pipe Connection Cleaning Caution .
High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.
- Relieve the fuel system pressure. Fuel Pressure Relief
- Engine Rear Noise Shield - Remove - Engine Rear Noise Shield Replacement
Fuel Feed Pipe (1) - Disconnect - Metal Collar Quick Connect Fitting Service
Wiring Harness Retainer (1) @ Bracket - Remove [2x]
Fuel Feed Pipe Fitting (1) @ Fuel Pump - Remove
- Fuel Injection Fuel Feed and Return Pipe Retainer Bolt (2) - Remove [2x]
- Remove and DISCARD the fuel feed pipe (3).