Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Suburban 3500 HD LS >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.0L (L96) - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

NOTE:

Perform the Crankshaft Position Variation Learn  whenever the crankshaft position sensor is removed or replaced.

    Fig 1: Engine Wiring Harness Electrical Connectors And Components
    GM1698087Courtesy of GENERAL MOTORS COMPANY
  1. Remove the starter. Refer to Starter Replacement (L96) .
  2. Working through the wheel well opening, disconnect the engine wiring harness electrical connector (1) from the crankshaft position (CKP) sensor.
    3. Fig 2: CKP Sensor And Bolt
    GM1239292Courtesy of GENERAL MOTORS COMPANY
  3. Clean the area around the CKP sensor before removal in order to avoid debris from entering the engine.
  4. Remove the CKP sensor bolt.
  5. Remove the CKP sensor.
scientia non olet · About Mike's Workshop Manuals