Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas >> Repair and Diagnosis >> Body & Frame >> Towing Systems >> Trailer Brake Controls System >> Repair Instructions >> Trailer Brake Power Control Module Replacement (J95, J96) >> Installation Procedure

Installation Procedure

    Fig 1: Trailer Brake Power Control Module Component Location
    GM3618304Courtesy of GENERAL MOTORS COMPANY
  1. Install the trailer brake power control module (1) to the bracket.
    2. Fig 2: Trailer Brake Power Control Module And Nuts
    GM3618302Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Fastener Caution .

  2. Install the trailer brake power control module nuts (1) and tighten to 9 N.m (80 lb in).
    3. Fig 3: Trailer Brake Power Control Module Bracket Bolts
    GM2411535Courtesy of GENERAL MOTORS COMPANY
  3. Install the chassis control and trailer brake power control module bracket assembly to the frame.
  4. Slide the chassis control and trailer brake power control module bracket assembly fully into the slotted holes of the vehicle frame.
  5. Tighten the chassis control and trailer brake power control module bracket bolts (1) to 9 N.m (80 lb in).
  6. Connect the chassis control and trailer brake power control module electrical connectors.
  7. Raise and secure the spare tire and wheel assembly.
scientia non olet · About Mike's Workshop Manuals