Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas/Ethanol >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Vehicle Access System >> Diagnostic Information And Procedures >> DTC B252E: Child Security Lock Switch Indicator Circuit >> Circuit/System Testing

Circuit/System Testing

  1. Ignition/Vehicle & All vehicle systems - Off
  2. Connect a test lamp between the test points: Control circuit terminal 11 & Ground
  3. Ignition - On/Vehicle - In Service Mode
  4. Perform the scan tool control function: Child Security Lock Indicator Command - Active & Inactive

    Verify the test lamp turns On and Off.

    • If the test lamp is always Off 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical Connector: X1 @ K9 Body Control Module
    3. Test for infinite resistance between the test points: Control circuit terminal 11 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance
    4. Test for less than 2 ohms between the test points: Control circuit terminal 11 @ Component harness & Control circuit terminal 5 X1 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K9 Body Control Module
    • If the test lamp is always On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical Connector: X1 @ K9 Body Control Module
    3. Ignition - On/Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 11 @ Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V - Replace the component: K9 Body Control Module
    • Go to next step: If the test lamp turns On and Off 
  5. Connect a test lamp between the test points: Control circuit terminal 12 & B+
  6. Perform the scan tool control function: Child Security Lock Indicator Command - Active & Inactive

    Verify the test lamp turns On and Off.

    • If the test lamp is always Off 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical Connector: X2 @ K9 Body Control Module
    3. Ignition - On/Vehicle - In Service Mode
    4. Test for less than 1 V between the test points: Control circuit terminal 12 @ Component harness & Ground
      • If 1 V or greater - Repair the short to voltage on the circuit.
      • If less than 1 V
    5. Ignition/Vehicle - Off
    6. Test for less than 2 ohms between the test points: Control circuit terminal 12 @ Component harness & Control circuit terminal 6 X2 @ Control module harness
      • If 2 ohms or greater - Repair the open/high resistance in the circuit.
      • If less than 2 ohms - Replace the component: K9 Body Control Module
    • If the test lamp is always On 
    1. Ignition/Vehicle - Off & Remove - Test lamp
    2. Disconnect the electrical Connector: X2 K9 Body Control Module
    3. Test for infinite resistance between the test points: Control circuit terminal 12 @ Component harness & Ground
      • If less than infinite resistance - Repair the short to ground on the circuit.
      • If infinite resistance - Replace the component: K9 Body Control Module
    • Go to next step: If the test lamp turns On and Off 
  7. Test or replace the component: S79D Window Switch - Driver
scientia non olet · About Mike's Workshop Manuals