Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Express 2500 Base, Van Cargo Extended, 2.8L Eng VIN 1 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions >> Repair Instructions >> Fuel Injection Pump Metering Valve Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (Single Battery)Battery Negative Cable Disconnection and Connection (Dual Battery)
  2. Engine Mount Bracket-Left Side - Remove - Engine Mount Bracket Replacement - Left Side
  3. GM4854948Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector (1).

  4. GM4854539Courtesy of GENERAL MOTORS COMPANY

    Remove the fuel feed and return harness bracket nut (1).

  5. Remove the fuel feed hose protector bolt (2).
  6. Remove the fuel feed hose protector (3).
  7. GM4854567Courtesy of GENERAL MOTORS COMPANY

    Remove the fuel injection pump metering valve fasteners (1).

  8. Remove the fuel injection pump metering valve (2).

    Remove and DISCARD the fuel injection pump metering valve o-ring seal. The seal is NOT shown.

scientia non olet · About Mike's Workshop Manuals