Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Express 2500 Base, Van Cargo Extended, 2.8L Eng VIN 1 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. GM4622964Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Do not allow the crankshaft position sensor reluctor ring to come into contact with external magnetic fields or sharp metal objects. Do not drop the crankshaft position sensor reluctor ring. Do not damage the rubberized encoder track. Failure to follow these precautions may cause damage to the component.

    Crankshaft Position Sensor (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Crankshaft Position Sensor Bolt (1) - Install and tighten to 5 N.m (44 lb in)
  3. GM4622881Courtesy of GENERAL MOTORS COMPANY

    Crankshaft Position Sensor Bracket (2) - Install

  4. Crankshaft Position Sensor Bracket Bolt (1) - Install and tighten [2x] 9 N.m (80 lb in)
  5. GM4622853Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (2) @ Crankshaft Position Sensor Bracket (3) - Install [2x]

  6. Engine Wiring Harness (1) @ Electrical Connector (2) - Connect
  7. Remove the supports and lower the vehicle. Lifting and Jacking the Vehicle
  8. Perform the crankshaft position variation learn. Crankshaft Position Variation Learn 
scientia non olet · About Mike's Workshop Manuals