Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2018 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions >> Repair Instructions >> Fuel Feed Intermediate Pipe Replacement - High Pressure >> Removal Procedure

Removal Procedure

WARNING:

The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage, and possible injury or death.

NOTE:

High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.

  1. Relieve the fuel system pressure. Fuel Pressure Relief 
  2. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
  3. Engine Sight Shield - Remove - Engine Sight Shield Replacement
  4. Remove the charge air cooler outlet air hose from the throttle body. Charge Air Cooler Outlet Air Hose Replacement 
  5. GM3682444
    NOTE:

    Lay a lint-free cloth under the fuel feed intermediate pipe.

    Remove the fuel feed intermediate pipe bracket bolt (3).

  6. Loosen the fuel feed intermediate pipe fittings (2, 5) at the fuel pump (6) and the fuel injection fuel rail (1).
  7. Remove and DISCARD the fuel feed intermediate pipe (4).
scientia non olet · About Mike's Workshop Manuals