Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.5L (L3A) - Repair Instructions >> Repair Instructions >> Exhaust Gas Recirculation Cooler Outlet Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Exhaust Gas Recirculation Cooler Outlet Pipe And Seals
    GM4091558Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW seal.(1, 3)
  2. Install Exhaust Gas Recirculation Cooler Outlet Pipe (3)
    3. Fig 2: Exhaust Gas Recirculation Pipe Bolts
    GM4091555Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT tighten.

  3. Install Exhaust Gas Recirculation Pipe Bolt (1)
    4. Fig 3: EGR Temperature Sensor - Position 2, EGR Cooler And Bolts
    GM4091535Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do NOT tighten.

  4. Install Exhaust Gas Recirculation Pipe Bolt (3) @Exhaust Gas Recirculation Cooler (1)
    5. CAUTION:

    Fastener Caution

  5. Exhaust Gas Recirculation Pipe Bolt (3) - Tighten 10 N.m (89 lb in)
    6. Fig 4: Exhaust Gas Recirculation Pipe Bolts
    GM4091555Courtesy of GENERAL MOTORS COMPANY
  6. Exhaust Gas Recirculation Cooler Bolt (1) - Tighten 10 N.m (89 lb in)
    7. Fig 5: EGR Temperature Sensor - Position 2, EGR Cooler And Bolts
    GM4091535Courtesy of GENERAL MOTORS COMPANY
  7. Install the exhaust gas recirculation temperature sensor - position 2 (2) and tighten to 42 N.m (31 lb ft).
  8. Install Three-Way Catalytic Converter Replacement
  9. Install Water Outlet Replacement
  10. Install Air Cleaner Outlet Duct Replacement 
  11. Install Dash Upper Extension Panel Opening Cover Replacement
scientia non olet · About Mike's Workshop Manuals