Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> Volt Premier >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> Power Mode Mismatch >> Circuit/System Verification

Circuit/System Verification

NOTE:

Use schematics to determine which ignition relay supplies the ignition feed for the appropriate devices. Use the connector end view to identify the ignition circuit terminal for each of those devices.

  1. Vehicle in Service Mode.
  2. Verify that the appropriate devices controlled by the KR73 Ignition Main Relay turn ON and OFF when commanding the Run/Crank Relay On and Off with a scan tool.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic A.

    • If the devices turn ON and OFF 
  3. Verify that the appropriate devices controlled by the KR75 Engine Controls Ignition Relay turn ON and OFF when cycling the between Vehicle in Service Mode and Vehicle OFF.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic B.

    • If the devices turn ON and OFF 
  4. Verify that the appropriate devices controlled by the KR76 Retained Accessory Power Relay turn ON and OFF when cycling the between Vehicle in Service Mode and Vehicle OFF.
    • If the devices do not turn ON and OFF 

      Refer to Circuit/System Testing - Diagnostic C.

    • If the devices turn ON and OFF 
  5. All OK.
scientia non olet · About Mike's Workshop Manuals