Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> Traverse LS Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust >> Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor Bolt & Sensor - Bank 2 (Left Side) Exhaust
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the CMP sensor (4) and bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    2. Fig 2: Intake & Exhaust Camshaft Position (CMP) Sensors - Bank 2 (Left Side) Exhaust
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (3) to the bank 2 exhaust CMP sensor (4).
  3. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
scientia non olet · About Mike's Workshop Manuals