Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> SS Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Engine Mechanical - 6.2L (LS3) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

  1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Passenger Side)Air Inlet Grille Panel Replacement (Driver Side) .
    2. Fig 1: Oil Pressure Sensor Wiring Harness Connector
    GM1951036Courtesy of GENERAL MOTORS COMPANY
  2. Disconnect the oil pressure sensor wiring harness connector (1).
    3. Fig 2: Oil Pressure Sensor & Switch Socket
    GM1951038Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean the area around the oil pressure sensor (2) before removal. This prevents debris from entering the engine.

  3. Use the J 41712  oil pressure switch socket (1) to remove the oil pressure sensor (2).
scientia non olet · About Mike's Workshop Manuals