Removal Procedure

Front Bumper Fascia - Remove Front Bumper Fascia Replacement .
Disconnect and reposition harness as necessary.
Remove the sensor (1) from the sensor bracket.

Fig 1: Front Parking Assist Alarm Sensor
Courtesy of GENERAL MOTORS COMPANY
Using a flat bladed tool carefully remove the bracket (1) from the fascia.

Fig 2: Front Parking Assist Alarm Sensor Bracket
Courtesy of GENERAL MOTORS COMPANY
Sand sonic weld plastic residue (1) from the fascia.

Fig 3: Structural Adhesive Epoxy
Courtesy of GENERAL MOTORS COMPANY

NOTE: Do Not sand off alignment tabs/outline.