Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> Express 2500 Base, Van Cargo, 2.8L Eng VIN 1 >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.8L (LWN) Diesel - Repair Instructions >> Repair Instructions >> Exhaust Gas Recirculation Cooler Temperature Sensor Replacement - Position 1 >> Removal Procedure

Removal Procedure

  1. Remove Charge Air Cooler Inlet Air Hose - Refer to Charge Air Cooler Inlet Air Hose Replacement 
  2. Remove Engine Cover - Refer to Engine Cover Replacement
  3. Disconnect the electrical connector (1).
  4. Remove the exhaust gas recirculation (EGR) cooler temperature sensor wiring clip (2) from the bracket (3).
  5. Remove the EGR cooler temperature sensor wiring (4) from the clip (5).
    6. NOTE:

    Apply penetrating oil to the sensor and allow to soak for 10 minutes prior to removal.

  6. Use a suitable deep, flare nut socket designed for removing/installing sensors to remove the EGR cooler temperature sensor (1).
scientia non olet · About Mike's Workshop Manuals