Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2017 >> Camaro SS, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L (LT1 LT4) - Repair Instructions >> Repair Instructions >> Fuel Tank Replacement >> Removal Procedure

Removal Procedure

    WARNING:

    To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

    WARNING:

    Refer to Gasoline/Gasoline Vapors Warning .

    WARNING:

    Refer to Safety Glasses Warning .

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief 
  2. Drain the fuel tank. Refer to Fuel Tank Draining 
  3. Remove Two-Piece Propeller Shaft. Refer to Two-Piece Propeller Shaft Replacement (Coupe MM6, M13, MJK)Two-Piece Propeller Shaft Replacement (Convertible MM6, M13, MJK)Two-Piece Propeller Shaft Replacement (Coupe M5T, M5U, MGL)Two-Piece Propeller Shaft Replacement (Convertible M5T, M5U, MGL)
  4. Remove the left front rear suspension bracket. Refer to Rear Suspension Bracket Replacement (Rear (Coupe))Rear Suspension Bracket Replacement (Front)
  5. Remove Transmission Fluid Cooler Pipe - Mid Line Left and Mid Line Right. Refer to Transmission Fluid Cooler Pipe Replacement (LT4 With MJK and KNR, LT1 With MM6, With KNR, Mid Line Left)Transmission Fluid Cooler Pipe Replacement (LT4 With MJK and KNR, LT1 With MM6, With KNR, Mid Line Right)Transmission Fluid Cooler Pipe Replacement (LT1 With M5U, With KNR, Mid Line Left)Transmission Fluid Cooler Pipe Replacement (LT1 With M5U, With KNR, Mid Line Right)Transmission Fluid Cooler Pipe Replacement (LT4 With MGL, With KNR, Mid Line Left)Transmission Fluid Cooler Pipe Replacement (LT4 With MGL, With KNR, Mid Line Right)
    6. Fig 1: Electrical Connector
    GM4180643Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect Electrical Connector (1)
    7. Fig 2: Fuel Tank Filler Hose, Evap. Emission Canister Hoses And Clamp
    GM4182848Courtesy of GENERAL MOTORS COMPANY
  7. Remove Fuel Tank Filler Hose Clamp (1)
  8. Remove Fuel Tank Filler Hose (2)
  9. Disconnect Evaporative Emission Canister Hose (3). Refer to Plastic Collar Quick Connect Fitting Service 
  10. Disconnect Evaporative Emission Canister Purge Hose (4). Refer to Plastic Collar Quick Connect Fitting Service 
    11. Fig 3: Fuel Feed Pipe And Evaporative Emission Pipe
    GM4182877Courtesy of GENERAL MOTORS COMPANY
  11. Disconnect Fuel Feed Pipe (1). Refer to Plastic Collar Quick Connect Fitting Service 
  12. Disconnect Evaporative Emission Pipe (2). Refer to Plastic Collar Quick Connect Fitting Service 
    13. Fig 4: Fuel Tank Straps And Bolts
    GM4295664Courtesy of GENERAL MOTORS COMPANY
  13. Support the fuel tank with a suitable jack.
  14. Remove Fuel Tank Strap Bolts (1) (Qty: 3)
  15. Remove Fuel Tank Strap Bolts (2) (Qty: 2)
  16. Remove Fuel Tank Straps (3) (Qty: 2)
    17. Fig 5: Fuel Tank
    GM4183662Courtesy of GENERAL MOTORS COMPANY
  17. Remove Fuel Tank (1)
  18. Transfer components as necessary.
scientia non olet · About Mike's Workshop Manuals