Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Trax LS, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.4L (LUV) - Repair Instructions >> Repair Instructions >> Charge Air Bypass Valve Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Charge Air Bypass Valve Piston/Membrane
    GM4033157Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure there is no dirt or debris in the turbocharger housing valve cavity.

  1. Charge Air Bypass Valve Membrane (3) - Install
  2. Charge Air Bypass Valve Piston (2) - Install
  3. Valve Spring (1) - Install
    4. Fig 2: Charge Air Bypass Valve Cover
    GM4033086Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The charge air bypass valve piston guide pin fits inside the charge air bypass valve cover guide bore.

  4. Charge Air Bypass Valve Cover (2) - Install
    5. CAUTION:

    Refer to Fastener Caution .

  5. Fastener (1) - Install & Tighten the bolts until snug.
  6. Fastener (1) - Tighten 12 N.m (106 lb in)
  7. Use GE-23738-A  Vacuum Pump to check for vacuum leak.
    8. Fig 3: Charge Air Bypass Valve Tube
    GM4033059Courtesy of GENERAL MOTORS COMPANY
  8. Hose Clamp (1) @Charge Air Bypass Valve Tube Connector (2) - Loosely install
  9. Charge Air Bypass Valve Tube Connector (2) - Install
  10. Hose Clamp (1) @ Charge Air Bypass Valve Tube Connector (2) - Move into position & Tighten
  11. Turbocharger Wastegate Actuator - Install - Turbocharger Assemble
  12. Exhaust Manifold Heat Shield Installation - Install
scientia non olet · About Mike's Workshop Manuals